For low-cost RFID systems, the design of passive tags is a key issue in anti-collision protocols where lower power consumption allows a longer working distance between tags and the reader. In this paper, we look at anti-collision protocols in tags' processing for their power optimization. We propose a new criterion, which takes into account both energy consumption and time complexity, to evaluate anti-collision protocols. An improved protocol is also presented for power savings.

No abstract

Fixed pattern noise (FPN) for a CCD sensor is modeled as a sample of a spatial white noise process. This model is, however, not adequate for characterizing FPN in CMOS sensors, since the readout circuitry of CMOS sensors and CCDs are very different. The paper presents a model for CMOS FPN as the sum of two components: a column and a pixel component. Each component is modeled by a first order isotropic autoregressive random process, and each component is assumed to be uncorrelated with the other. The parameters of the processes characterize each component of the FPN and the correlations between neighboring pixels and neighboring columns for a batch of sensors. We show how to estimate the model parameters from a set of measurements, and report estimates for 64x64 passive pixel sensor (PPS) and active pixel sensor (APS) test structures implemented in a 0.35 micron CMOS process. High spatial correlations between pixel components were measured for the PPS structures, and between the column components in both PPS and APS. The APS pixel components were uncorrelated.

This paper presents a wirelessly powered implantable electrochemical sensor tag for continuous blood glucose monitoring. The system is remotely powered by a 13.56-MHz inductive link and utilizes an ISO 15693 radio frequency identification (RFID) standard for communication. This paper provides reliable and accurate measurement for changing glucose level. The sensor tag employs a long-term glucose sensor, a winding ferrite antenna, an RFID front-end, a potentiostat, a 10-bit sigma-delta analog to digital converter, an on-chip temperature sensor, and a digital baseband for protocol processing and control. A high-frequency external reader is used to power, command, and configure the sensor tag. The only off-chip support circuitry required is a tuned antenna and a glucose microsensor. The integrated chip fabricated in SMIC 0.13-μm CMOS process occupies an area of 1.2 mm ×2 mm and consumes 50 μW. The power sensitivity of the whole system is -4 dBm. The sensor tag achieves a measured glucose range of 0-30 mM with a sensitivity of 0.75 nA/mM.

No abstract

No abstract

No abstract

No abstract